2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This circuit sends a signal to the stereo component amplifier assembly to mute noise. Because of that, the noise produced by changing the sound source ceases.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the stereo component amplifier assembly is functioning, no sound, or only an extremely faint sound, can be heard.

WIRING DIAGRAM

E153585E20

INSPECTION PROCEDURE


1. INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY

  1. E151934E13
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F18-1 (MUTE) - Body ground
    Engine switch on (ACC), audio system is playing → Changing sources
    Above 2.5 V → Below 0.5 V

    Text in Illustration 
    *1
    Component with harness connected
    (Stereo Component Amplifier Assembly)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER)
  1. Disconnect the F1 radio receiver assembly and F18 stereo component amplifier assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F1-7 (MUTE) - F18-1 (MUTE)
    Always
    Below 1 Ω
    F1-7 (MUTE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY (OUTPUT SIGNAL)

  1. E151935E41
    Reconnect the F18 stereo component amplifier assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F1-7 (MUTE) - Body ground
    Engine switch on (ACC), audio system is playing
    Above 2.5 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Radio Receiver Assembly)



NG
REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY (Click here)
OK

REPLACE RADIO RECEIVER ASSEMBLY (Click here)


← Sound Signal Circuit between Multi-media Interface ECU and Stereo Jack Adapter (from Jan 2012)Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier (from Jan 2012) →