Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier
Circuit diagnosis · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
This circuit sends a signal to the stereo component amplifier assembly to mute noise. Because of that, the noise produced by changing the sound source ceases.If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the stereo component amplifier assembly is functioning, no sound, or only an extremely faint sound, can be heard.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY |
Measure the voltage according to the value(s) in the table below.

- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
F18-1 (MUTE) - Body ground
Engine switch on (ACC), audio system is playing → Changing sources
Above 2.5 V → Below 0.5 V
Text in Illustration *1
Component with harness connected
(Stereo Component Amplifier Assembly)
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER) |
Disconnect the F1 radio receiver assembly and F18 stereo component amplifier assembly connectors.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
F1-7 (MUTE) - F18-1 (MUTE)
Always
Below 1 Ω
F1-7 (MUTE) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 3. INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY (OUTPUT SIGNAL) |
Reconnect the F18 stereo component amplifier assembly connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
F1-7 (MUTE) - Body ground
Engine switch on (ACC), audio system is playing
Above 2.5 V
Text in Illustration *1
Front view of wire harness connector
(to Radio Receiver Assembly)
|
|
||||
| OK | ||
| ||
