The Other Caller cannot Hear Your Voice, or Your Voice is too Quiet or Distorted
Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011
INSPECTION PROCEDURE
| 1. CHECK CELLULAR PHONE |
 |
Check if the other caller can hear your voice correctly.
- OK:
- Your voice can be heard correctly.
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 2. CHECK SETTINGS |
 |
- Check if the mute switch is set to on.
- OK:
- Mute switch is not set to on.
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 3. CHECK SETTINGS (OPERATION CHECK) |
 |
- Enter the "Hand-free Volume Setting" screen. Refer to "Check Hands-free Volume Setting" in Operation Check (Click here).
Adjust "Send Voice Level" and check that the other caller an hear your voice.
- HINT:
- Adjusting "Send Voice Level" may deteriorate the sound quality.
- The "Send Voice Level" can be set to 10 different levels, -5 to +4.
- OK:
- Malfunction disappears.
|
NG |
 |
|
|
|
| OK |
|
 |
|
|
| 4. CHECK MICROPHONE (OPERATION CHECK) |
 |
- Enter the "Microphone & Voice Recognition Check" screen. Refer to Check Mic & Voice Recognition in Operation Check (Click here).
When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.
Push the recording switch and perform voice recording.
- HINT:
- Voice can be recorded up to 5 seconds.
Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.
- OK:
- All check results are normal.
|
NG |
 |
|
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|
|
| OK |
|
 |
|
| 5. REPLACE RADIO RECEIVER ASSEMBLY |
 |
Replace the radio receiver assembly (Click here).
Check symptoms again.
- OK:
- The other caller can hear your voice loud enough without noise or distortion.
|
NG |
 |
|
| REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY (Click here)
|
|
|
| OK |
|
 |
|
|