2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Display Signal Circuit between Navigation ECU and Video Terminal

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

This is the display signal circuit from the video terminal to the display and navigation module display.

WIRING DIAGRAM

E181637E05

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (VIDEO TERMINAL - NAVIGATION ECU)
  1. Disconnect the P1 headphone terminal connector.

  1. Disconnect the F61 display and navigation module display connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    P1-13 (VV+) - F61-2 (VV+)
    Always
    Below 1 Ω
    P1-14 (VV-) - F61-6 (VV-)
    Always
    Below 1 Ω
    P1-8 (ADPG) - F61-8 (ADPG)
    Always
    Below 1 Ω
    F61-2 (VV+) - Body ground
    Always
    10 kΩ or higher
    F61-6 (VV-) - Body ground
    Always
    10 kΩ or higher
    F61-5 (SG) - Body ground
    Always
    10 kΩ or higher
    F61-8 (ADPG) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Display Signal Circuit between Television Display Assembly and Navigation Receiver Assembly (Sep 2011 – Dec 2011)Sound Signal Circuit between Multi-media Interface ECU and Video Terminal (Sep 2011 – Dec 2011) →