AVC-LAN Circuit
Circuit diagnosis · Vehicles built from Jan 2012
DESCRIPTION
Each audio system component connected to the AVC-LAN (communication bus) transfers switch signals using the audio visual communication local area network.If a short to +B or short to ground occurs in the AVC-LAN, the audio system will not function normally because communication is not possible.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT MULTI-MEDIA MODULE RECEIVER ASSEMBLY |
Remove the multi-media module receiver assembly (Click here).

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
7 (TX1+) - 8 (TX1-)
Always
60 to 80 Ω
45 (TX3+) - 46 (TX3-)
Always
60 to 80 Ω
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - BATTERY AND BODY GROUND) |
- HINT:
- For details of the connectors, refer to Terminals of ECU (Click here).
Referring to the following AVC-LAN wiring diagram, check all AVC-LAN circuits.
Disconnect all connectors in all AVC-LAN circuits.
Check for an open or short in all AVC-LAN circuits.
- OK:
- There is no open or short circuit.
|
|
||||
| OK | |
| 3. INSPECT MALFUNCTIONING PARTS |
Disconnect and reconnect each slave unit one by one until the master unit returns to normal operation.
- HINT:
- Check all slave units.
- When disconnecting a slave unit causes the master unit to return to normal operation, this indicates that the slave unit is malfunctioning. Replace the malfunctioning slave unit.
- Check all slave units.
- OK:
- Master unit returns to normal operation.
|
|
||||
| OK | ||
| ||
