2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Parking Brake Switch Circuit

Circuit diagnosis · Vehicles built from Jan 2012

DESCRIPTION

This circuit is from the parking brake switch assembly to the multi-media module receiver assembly.

WIRING DIAGRAM

E250925E02

INSPECTION PROCEDURE


1. CHECK VEHICLE SIGNAL (OPERATION CHECK)

  1. E225776E02
    Enter the "Function Check/Setting I" mode and select "Vehicle Signal" (Click here).

  1. Check that the display changes between ON and OFF according to the parking brake operation.

    OK:
    Parking Brake Position
    Display
    Applied
    ON
    Released
    OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual change in the switch.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - MULTI-MEDIA MODULE RECEIVER ASSEMBLY)
  1. Disconnect the E53 parking brake switch assembly connector.

  1. Disconnect the F77 multi-media module receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F77-55 (PKB) - E53-1
    Always
    Below 1 Ω
    F77-55 (PKB) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT PARKING BRAKE SWITCH ASSEMBLY

  1. E248885
    Remove the parking brake switch assembly connector (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - Switch body
    ON (Shaft not pressed)
    Below 1 Ω
    OFF (Shaft pressed)
    10 kΩ or higher

    Text in Illustration 
    V100135
    ON
    V100136
    OFF



NG
REPLACE PARKING BRAKE SWITCH ASSEMBLY (Click here)
OK

REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY (Click here)


← Illumination Circuit (from Jan 2012)AVC-LAN Circuit (from Jan 2012) →