Power Steering Warning Light Circuit
Circuit diagnosis · Vehicles built from Jan 2012
DESCRIPTION
The power steering ECU is connected to the combination meter via CAN communication. If the power steering ECU detects a malfunction, the power steering warning light comes on. At this time, the vehicle enters fail-safe mode.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. INSPECT CAN COMMUNICATION SYSTEM |
Check for DTCs of the CAN communication system.for LHDRefer to the following procedures (Click here).for RHDRefer to the following procedures (Click here).
Result Result
Proceed to
DTC is not output.
A
DTC is output.
for LHD
B
for RHD
C
|
|
||||
|
|
||||
| A | |
| 2. CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BATTERY AND BODY GROUND) |
Disconnect the power steering ECU connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
E102-5 (IG) - Body ground
Engine switch on (IG)
11 to 14 V
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E102-3 (GND) - Body ground
Always
Below 1 Ω
Text in Illustration *a
Front view of wire harness connector
(to Power Steering ECU)
|
|
||||
| OK | |
| 3. PERFORM ACTIVE TEST USING GTS (METER/GAUGE SYSTEM) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the GTS on.
Perform the Active Test of the combination meter using GTS (Click here).
Combination Meter Tester Display
Test Part
Control Range
Diagnostic Note
PPS Indicator
Power steering warning light
ON or OFF
Perform the test with the vehicle stopped and the engine idling.
Check that the power steering warning light operates in accordance with the Active Test.
- HINT:
- Reconnect the connectors and restore the vehicle to its previous condition before checking the combination meter.
- OK:
- The power steering warning light turns on and off in accordance with GTS operation.
|
|
||||
| OK | ||
| ||
