2011-2013 Land Cruiser · Service Manual Suspension

C1785 Steering Control ECU Communication Error

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The suspension control ECU receives signals from the steering control ECU via CAN communication.
DTC Code
Detection Condition
Trouble Area
C1785
While the engine switch is on (IG), the steering control ECU malfunction signal is received for 5 seconds.
  1. Variable gear ratio steering system (VGRS system)
  2. Suspension control ECU

INSPECTION PROCEDURE

NOTICE:
  1. Before performing troubleshooting, inspect the connectors of related circuits.
  2. If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed (Click here).


1. CHECK DTC (VARIABLE GEAR RATIO STEERING SYSTEM)
  1. Check if a DTC is output from the variable gear ratio steering system (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO VARIABLE GEAR RATIO STEERING SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) (Click here)
A


2. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3. CHECK DTC
  1. Check for DTCs.

    Result 
    Result
    Proceed to
    DTC C1785 is output
    A
    DTC C1785 is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE SUSPENSION CONTROL ECU (Click here)


← C1784 Steering Angle Sensor Communication Error (from Jan 2012)C1785 Steering Control ECU Communication Error (from Jan 2012) →