C1784 Steering Angle Sensor Communication Error
Diagnostic trouble codes · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
The steering sensor signal is sent to the suspension control ECU through the CAN communication system. When there is a communication malfunction, it will be detected by the diagnosis function.| DTC Code |
Detection Condition |
Trouble Area |
| C1784 |
A steering angle sensor signal malfunction is detected, or the steering angle sensor power malfunction signal is detected for 5 seconds or more. |
|
INSPECTION PROCEDURE
- NOTICE:
- Before performing troubleshooting, inspect the connectors of related circuits.
- If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed (Click here).
- Before performing troubleshooting, inspect the connectors of related circuits.
| 1. CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM) |
Check if a steering sensor malfunction DTC is output under the vehicle stability control system (Click here).
Result Result
Proceed to
DTC is not output
A
DTC is output
B
|
|
||||
| A | |
| 2. CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 3. CHECK DTC |
Check for DTCs.
Result Result
Proceed to
DTC C1784 is output
A
DTC C1784 is not output
B
|
|
||||
| A | ||
| ||
