C1719 Oil Temperature Sensor Circuit Malfunction
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
This circuit is used for sending the data to detect the fluid temperature of the pump. The abnormality of the fluid is judged by the ECU.| DTC Code |
Detection Condition |
Trouble Area |
| C1719 |
When one of the following conditions is met:
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Before performing troubleshooting, inspect the connectors of related circuits.
- If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed (Click here).
- Before performing troubleshooting, inspect the connectors of related circuits.
| 1. READ VALUE USING INTELLIGENT TESTER (OIL TEMPERATURE SENSOR) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and the tester on.
Select the Data List mode on the intelligent tester.
Check the fluid temperature value of the temperature sensor displayed on the intelligent tester.
AHC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Oil Temperature Sensor
Fluid temperature sensor reading /
min.: -3276.8°C (-5866.24°F)
max.: 3276.7°C (5930.06°F)
Actual fluid temperature
-
- OK:
- Same as actual fluid temperature
|
|
||||
| OK | |
| 2. RECONFIRM DTC OUTPUT |
Clear the DTCs (Click here).
Perform a road test.
Check for DTCs.
Result Result
Proceed to
DTC C1719 is output
A
DTC C1719 is not output
B
|
|
||||
| A | ||
| ||
| 3. CHECK HARNESS AND CONNECTOR (TEMPERATURE SENSOR - SUSPENSION CONTROL ECU) |
- NOTICE:
- When inspecting the wire harness between the suspension control ECU and temperature sensor, it is difficult to determine the malfunctioning area if there is a sensor power supply malfunction. Therefore, disconnect the connectors for the temperature sensor, the acceleration sensors (front RH, front LH) and pressure accumulator sensor on the ECU side.
Disconnect the K34 and K35 ECU connectors.
Disconnect the i1 sensor connector.


Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
K35-17 (TOIL) - i1-2 (TOIL)
Always
Below 1 Ω
K35-17 (TOIL) - Body ground
Always
10 kΩ or higher
K35-18 (STG) - i1-1 (SBL)
Always
Below 1 Ω
K35-18 (STG) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 4. INSPECT FLUID TEMPERATURE SENSOR |
![]() ![]() |
Connect the i2 temperature sensor connector.
Disconnect the K34 and K35 ECU connectors.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
K35-17 (TOIL) - K35-18 (STG)
20°C (68°F)
2.32 to 2.59 kΩ
|
|
||||
| OK | ||
| ||

