2011-2013 Land Cruiser · Service Manual Brake

DIAGNOSIS SYSTEM

Troubleshooting · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


DIAGNOSIS
  1. If the skid control ECU detects a malfunction, the ABS/BRAKE warning lights will come on to warn the driver.
    The table below indicates which lights will come on when there is a malfunction in a particular function.

Item/Trouble Area
Multi-terrain ABS
BA
EBD
ABS Warning Light
○
○
○
BRAKE Warning Light
-
-
○

HINT:
  1. ○: Light on
  2. -: Light off

  1. The DTCs are simultaneously stored in memory. The DTCs can be read by connecting SST between terminals 13 (TC) and 4 (CG) of the DLC3 and observing the blinking of the ABS warning light, or by connecting the intelligent tester.
  2. This system has a signal check function (test mode).

WARNING LIGHT CHECK
  1. Release the parking brake lever.

    NOTICE:
    When releasing the parking brake, set chocks to hold the vehicle for safety.

    HINT:
    When the parking brake is applied or the level of the brake fluid is low, the BRAKE warning light comes on.

  2. When the ignition switch is turned to ON, check that the ABS and BRAKE warning lights turn on and then turn off after the engine starts.
    If a light remains on, proceed to troubleshooting for the light circuit below.

    Trouble Area
    See Procedure
    ABS warning light circuit
    Click here
    BRAKE warning light circuit
    Click here

← TERMINALS OF ECU (from Jan 2012)DIAGNOSIS SYSTEM (from Jan 2012) →