2011-2013 Land Cruiser · Service Manual Brake

C1210/36 Zero Point Calibration of Yaw Rate Sensor Undone

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Also covers:

DESCRIPTION

The skid control ECU receives signals from the yaw rate and G sensor via the CAN communication system.
The yaw rate sensor has a built-in G sensor.
If there is trouble in the bus lines between the yaw rate and G sensor and the CAN communication system, the DTCs U0123/62 (yaw rate sensor communication trouble) and U0124/95 (G sensor communication trouble) are stored.
DTC Code
DTC Detection Condition
Trouble Area
C1210/36
  1. The yaw rate sensor zero point stored in the ECU is cleared.
  2. Zero point calibration has not been completed.
  1. Yaw rate and G sensor
  2. Zero point calibration undone
  3. Harness or connector
  4. Master cylinder solenoid (Skid control ECU)
C1336/98
  1. The G sensor zero point stored in the ECU is cleared.
  2. Zero point calibration has not been completed.
  1. Yaw rate and G sensor
  2. Zero point calibration undone
  3. Harness or connector
  4. Master cylinder solenoid (Skid control ECU)

WIRING DIAGRAM

C173286E01

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).

HINT:
When U0073/94, U0100/65, U0114/38, U0123/62, U0124/95, U0126/63 or U0130/68 is output together with C1210/36 or C1336/98, inspect and repair the trouble areas indicated by U0073/94, U0100/65, U0114/38, U0123/62, U0124/95, U0126/63 or U0130/68 first.


1. CHECK SENSOR INSTALLATION
  1. Check that the yaw rate and G sensor is installed properly.

    OK:
    The sensor is tightened to the specified torque.
    The sensor is not tilted.



NG
INSTALL YAW RATE AND G SENSOR CORRECTLY (Click here)
OK


2. PERFORM ZERO POINT CALIBRATION OF YAW RATE AND G SENSOR
  1. Perform the zero point calibration of the yaw rate and G sensor (Click here).


NEXT


3. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Check if the same DTCs are output (Click here).

    HINT:
    Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    for LHD
    B
    for RHD
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

END


← C1210 Zero Point Calibration of Yaw Rate Sensor Undone (+ C1336) (from Jan 2012)C1223/43 ABS Control System Malfunction (Sep 2011 – Dec 2011) →