C1210 Zero Point Calibration of Yaw Rate Sensor Undone
Diagnostic trouble codes · Vehicles built from Jan 2012
Also covers:
- C1336 Zero Point Calibration of Acceleration Sensor Undone
DESCRIPTION
The skid control ECU (master cylinder solenoid) receives signals from the yaw rate sensor assembly via the CAN communication system.The yaw rate sensor assembly has a built-in acceleration sensor and detects the vehicle's condition using 2 circuits (GL1, GL2). If there is trouble in the bus lines between the yaw rate sensor assembly and the CAN communication system, DTCs U0123 (yaw rate sensor communication trouble) and U0124 (acceleration sensor communication trouble) are stored.
The DTCs are also stored when the calibration has not been completed.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1210 |
Zero point calibration of the yaw rate sensor is incomplete. |
|
| C1336 |
Zero point calibration of the acceleration sensor is incomplete. |
INSPECTION PROCEDURE
- NOTICE:
- After replacing the master cylinder solenoid, perform zero point calibration and store the system information (Click here).
- After replacing the yaw rate sensor assembly, perform zero point calibration (Click here).
- After replacing the master cylinder solenoid, perform zero point calibration and store the system information (Click here).
| 1. CHECK DTC (CAN COMMUNICATION SYSTEM) |
Check for DTCs (Click here).
Result Result
Proceed to
CAN DTC is not output
A
CAN DTC is output (for LHD)
B
CAN DTC is output (for RHD)
C
|
|
||||
|
|
||||
| A | |
| 2. PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR |
Perform zero point calibration of the yaw rate and acceleration sensor (Click here).
| NEXT | |
| 3. PERFORM TEST MODE (SIGNAL CHECK) |
Turn the ignition switch off.
Perform the signal check in the Test Mode Procedure (Click here).
- OK:
- All test mode DTCs are cleared.
|
|
||||
| OK | ||
| ||
| 4. CHECK YAW RATE SENSOR ASSEMBLY INSTALLATION |
Turn the ignition switch off.
Check that the yaw rate sensor assembly has been installed properly (Click here).
- OK:
- The sensor is tightened to the specified torque.
- The sensor is not installed at an angle.
|
|
||||
| OK | |
| 5. READ VALUE USING GTS (YAW RATE AND ACCELERATION SENSOR) |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Deceleration Sensor
Acceleration sensor reading/ Min.: -18.525 m/s2, Max.: 18.387 m/s2
-
Changes continuously during acceleration/deceleration.
Deceleration Sensor2
Acceleration sensor 2 reading/ Min.: -18.525 m/s2, Max.: 18.387 m/s2
-
Changes continuously during acceleration/deceleration.
Yaw Rate Sensor
Yaw rate sensor/ Min.: -128°/s, Max.: 127°/s
Vehicle stationary: 0°/s
Right turn: -128 to 0°/s
Left turn: 0 to 127°/s
-
Check that the yaw rate and acceleration sensor output value is displayed on the GTS.
- OK:
- The yaw rate and acceleration sensor output value is normal.
| Result |
Proceed to |
| NG |
A |
| OK (for LHD) |
B |
| OK (for RHD) |
C |
|
|
||||
|
|
||||
| A | ||
| ||
