2011-2013 Land Cruiser · Service Manual Brake

C1336/98 Zero Point Calibration of Acceleration Sensor Undone

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

The skid control ECU receives signals from the G sensor.
DTC Code
DTC Detection Condition
Trouble Area
C1336/98
  1. The G sensor zero point stored in the ECU is cleared.
  2. Zero point calibration has not been completed.
  1. G sensor
  2. Zero point calibration undone
  3. Harness or connector
  4. Master cylinder solenoid (Skid control ECU)

WIRING DIAGRAM

C177519E01

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).


1. CHECK SENSOR INSTALLATION
  1. Check that the G sensor is installed properly.

    OK:
    The sensor is tightened to the specified torque.
    The sensor is not tilted.

    Result 
    Result
    Proceed to
    OK
    A
    NG
    for Automatic Transmission
    B
    for Manual Transmission
    C



B
INSTALL G SENSOR CORRECTLY (Click here)

C
INSTALL G SENSOR CORRECTLY (Click here)
A


2. PERFORM ZERO POINT CALIBRATION OF G SENSOR
  1. Perform the zero point calibration of the G sensor (Click here).


NEXT


3. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Check if the same DTCs are output (Click here).

    HINT:
    Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    LHD
    B
    RHD
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

END


← C1336 Zero Point Calibration of Acceleration Sensor Undone (from Jan 2012)C1337 Diameter of the Tire is not Uniform (from Jan 2012) →