2011-2013 Land Cruiser · Service Manual Brake

C1256/56 Accumulator Low Pressure

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

The accumulator pressure sensor is connected to the skid control ECU in the master cylinder solenoid.
C173281E01
DTC Code
DTC Detection Condition
Trouble Area
C1256/56
The fluid pressure inside the accumulator is below the standard value.
  1. Hydraulic brake booster
  2. Hydraulic brake booster pump motor
  3. Hydraulic brake booster pump motor circuit
  4. Accumulator pressure sensor

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).

HINT:
When C1251/51, C1253/53, or C1254/54 is output together with C1256/56, inspect and repair the trouble area indicated by C1251/51, C1253/53, or C1254/54 first.


1. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Turn the ignition switch off.

  1. Depress the brake pedal more than 20 times.

  1. Turn the ignition switch to ON.

  1. Wait for 99 seconds.

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B

    HINT:
    Excessive brake pedal operation results in abnormal accumulator pressure consumption. This is normal.



B
USE SIMULATION METHOD TO CHECK (Click here)
A


2. CHECK HYDRAULIC CIRCUIT
  1. Check the hydraulic circuit (Click here).

    OK:
    Hydraulic circuit is normal (No leakage).



NG
REPAIR HYDRAULIC CIRCUIT (Click here)
OK


3. READ VALUE USING INTELLIGENT TESTER (ACCUMULATOR SENSOR)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON and turn the intelligent tester on.

  1. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

ABS/VSC/TRC 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Accumulator Sensor
Accumulator pressure sensor reading / min.: 0.00 V, max.: 5.00 V
3.58 to 5 V
If the value is constant regardless of the pump operation, an accumulator pressure sensor malfunction is suspected.
  1. Check that the accumulator output value is normal.

    OK:
    Accumulator pressure sensor value is normal.

    Result
    Proceed to
    OK
    A
    NG
    for LHD
    B
    for RHD
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A


4. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    for LHD
    B
    for RHD
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← C1256 Accumulator Low Pressure (from Jan 2012)C1257 Power Supply Drive Circuit (from Jan 2012) →