2011-2013 Land Cruiser · Service Manual Brake

C1256 Accumulator Low Pressure

Diagnostic trouble codes · Vehicles built from Jan 2012

DESCRIPTION

Refer to DTC C1254 (Click here).
DTC Code
DTC Detection Condition
Trouble Area
C1256
The fluid pressure inside the accumulator is below the standard value.
  1. Hydraulic circuit
  2. Master cylinder solenoid (Accumulator pressure sensor)

INSPECTION PROCEDURE

NOTICE:
After replacing the master cylinder solenoid, perform zero point calibration and store the system information (Click here).

HINT:
When DTC C1251, C1253 or C1254 is output together with DTC C1256 inspect and repair the trouble area indicated by DTC C1251, C1253 or C1254 first.


1. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Depress the brake pedal more than 40 times.

  1. Turn the ignition switch to ON.

  1. Wait for 99 seconds.

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B

    HINT:
    Excessive brake pedal operation results in abnormal accumulator pressure consumption. This is normal.



B
CHECK FOR INTERMITTENT PROBLEMS (Click here)
A


2. CHECK HYDRAULIC CIRCUIT
  1. Check the hydraulic circuit (Click here).

    OK:
    Hydraulic circuit is normal (no leakage).



NG
REPAIR HYDRAULIC CIRCUIT
OK


3. READ VALUE USING GTS (ACCUMULATOR SENSOR)
  1. Turn the ignition switch off.

  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

ABS/VSC/TRC 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Accumulator Sensor
Accumulator pressure sensor reading/ Min.: 0.00 V, Max.: 5.00 V
3.58 to 5 V
If the value is constant regardless of the pump operation, an accumulator pressure sensor malfunction is suspected.
  1. Check that the accumulator output value is normal.

    OK:
    Accumulator pressure sensor value is normal.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for LHD)
    B
    NG (for RHD)
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A


4. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (for LHD)
    B
    DTC is output (for RHD)
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

CHECK FOR INTERMITTENT PROBLEMS (Click here)


← C1254/54 Pressure Switch Circuit (Sep 2011 – Dec 2011)C1256/56 Accumulator Low Pressure (Sep 2011 – Dec 2011) →