C1256/56 Accumulator Low Pressure
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
DESCRIPTION
The accumulator pressure sensor is connected to the skid control ECU in the master cylinder solenoid.

| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1256/56 |
The fluid pressure inside the accumulator is below the standard value. |
|
INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform zero point calibration (Click here).
- HINT:
- When C1251/51, C1253/53, or C1254/54 is output together with C1256/56, inspect and repair the trouble area indicated by C1251/51, C1253/53, or C1254/54 first.
| 1. RECONFIRM DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Depress the brake pedal more than 20 times.
Turn the ignition switch to ON.
Wait for 99 seconds.
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC is output
A
DTC is not output
B
- HINT:
- Excessive brake pedal operation results in abnormal accumulator pressure consumption. This is normal.
|
|
||||
| A | |
| 2. CHECK HYDRAULIC CIRCUIT |
Check the hydraulic circuit (Click here).
- OK:
- Hydraulic circuit is normal (No leakage).
|
|
||||
| OK | |
| 3. READ VALUE USING INTELLIGENT TESTER (ACCUMULATOR SENSOR) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
| Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
| Accumulator Sensor |
Accumulator pressure sensor reading / min.: 0.00 V, max.: 5.00 V |
3.58 to 5 V |
If the value is constant regardless of the pump operation, an accumulator pressure sensor malfunction is suspected. |
Check that the accumulator output value is normal.
- OK:
- Accumulator pressure sensor value is normal.
Result Result
Proceed to
OK
A
NG
LHD
B
RHD
C
|
|
||||
|
|
||||
| A | |
| 4. RECONFIRM DTC |
Clear the DTC (Click here).
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC is not output
A
DTC is output
LHD
B
RHD
C
|
|
||||
|
|
||||
| A | ||
| ||
