Skid Control Buzzer Circuit
Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
The skid control buzzer sounds while the accumulator pressure is abnormally low or an abnormality causing low fluid pressure occurs.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform zero point calibration (Click here).
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (BUZZER) |
 |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.
ABS/VSC/TRC
Tester Display
|
Test Part
|
Control Range
|
Diagnostic Note
|
Buzzer
|
Skid control buzzer
|
Buzzer ON/OFF
|
The buzzer can be heard.
|
Check that the buzzer sounds/stops when turning the skid control buzzer on/off by using the intelligent tester.
Result
Result
|
Proceed to
|
Buzzer sounds/stops
|
A
|
Buzzer does not sound or sounds constantly
|
B
|
|
A |
 |
|
|
|
| B |
|
 |
|
| 2. INSPECT SKID CONTROL BUZZER (POWER SOURCE TERMINAL) |
 |
- Disconnect the E5 skid control buzzer connector.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
|
Switch Condition
|
Specified Condition
|
E5-2 (IG1) - Body ground
|
Ignition switch ON
|
11 to 14 V
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| 3. INSPECT SKID CONTROL BUZZER |
 |
- Apply battery voltage to the skid control buzzer, and check that the buzzer sounds.
- OK:
Measurement Condition
|
Specified Condition
|
Battery positive (+) voltage - Terminal 2 (IG1)
|
Skid control buzzer sounds.
|
Battery negative (-) voltage - Terminal 1 (BZ)
|
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 4. CHECK HARNESS AND CONNECTOR (SKID CONTROL BUZZER - SKID CONTROL ECU) |
 |
- Disconnect the A24 skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
A24-30 (BZ) - E5-1 (BZ)
|
Always
|
Below 1 Ω
|
A24-30 (BZ) - Body ground
|
Always
|
10 kΩ or higher
|
Result
Result
|
Proceed to
|
NG
|
A
|
OK
|
LHD
|
B
|
RHD
|
C
|
|
B |
 |
|
|
|
|
C |
 |
|
|
|
| A |
|
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|