C0278/11 Open or Short Circuit in ABS Solenoid Relay Circuit
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
Also covers:
- C0279/12 Short to B+ in ABS Solenoid Relay Circuit
DESCRIPTION
The solenoid relay is built into the master cylinder solenoid.This relay supplies power to each solenoid. If the initial check is OK, after the ignition switch is turned to ON, the relay turns on.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C0278/11 |
When either of the following conditions is detected:
|
|
| C0279/12 |
The following condition continues for at least 0.2 seconds.
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform zero point calibration (Click here).
| 1. INSPECT ABS2 FUSE |
Remove the ABS2 fuse from the engine room relay block.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
ABS2 fuse
Always
Below 1 Ω
|
|
||||
| OK | |
| 2. INSPECT SKID CONTROL ECU (+BS TERMINAL) |
Install the ABS2 fuse.

Disconnect the A24 skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
A24-31 (+BS) - Body ground
Always
11 to 14 V
|
|
||||
| OK | |
| 3. INSPECT SKID CONTROL ECU (GND TERMINAL) |
Disconnect the A24 and A25 skid control ECU connectors.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
A24-1 (GND1) - Body ground
Always
Below 1 Ω
A24-32 (GND2) - Body ground
Always
Below 1 Ω
A25-4 (GND3) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | |
| 4. RECONFIRM DTC |
- HINT:
- These codes are stored when a problem is detected in the master cylinder solenoid.
- The ABS solenoid relay is in the master cylinder solenoid.
- Therefore, solenoid relay circuit inspection and relay unit inspection cannot be performed. Be sure to check if any DTC is output before replacing the master cylinder solenoid.
Clear the DTCs (Click here).
Drive the vehicle at a speed of approximately 32 km/h (20 mph) or more for 60 seconds or more.
Check if the same DTCs are output (Click here).
- HINT:
- Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.
Result Result
Proceed to
DTC is not output
A
DTC is output
for LHD
B
for RHD
C
|
|
||||
|
|
||||
| A | ||
| ||
