2011-2013 Land Cruiser · Service Manual Brake

C1254 Pressure Sensor or Switch

Diagnostic trouble codes · Vehicles built from Jan 2012

DESCRIPTION

The accumulator pressure sensor is connected to the skid control ECU in the master cylinder solenoid.
C173281E06
DTC Code
DTC Detection Condition
Trouble Area
C1254
There is an accumulator pressure sensor malfunction (the fluid pressure does not change when the pump operates or when the brake is applied).
Master cylinder solenoid (Accumulator pressure sensor)

INSPECTION PROCEDURE

NOTICE:
After replacing the master cylinder solenoid, perform zero point calibration and store the system information (Click here).


1. READ VALUE USING GTS (ACCUMULATOR SENSOR)
  1. Turn the ignition switch off.

  1. Connect the GTS to the DLC3.

  1. Depress the brake pedal more than 40 times.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

    ABS/VSC/TRC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Accumulator Sensor
    Accumulator pressure sensor reading/ Min.: 0.00 V, Max.: 5.00 V
    3.58 to 5 V
    If the value is constant regardless of the pump operation, an accumulator pressure sensor malfunction is suspected.

  1. Check the accumulator output value.

    Result 
    Result
    Proceed to
    Output value is within "Normal Condition" range
    A
    Output value is out of "Normal Condition" range (for LHD)
    B
    Output value is constant regardless of pump operation (for LHD)
    Output value is out of "Normal Condition" range (for RHD)
    C
    Output value is constant regardless of pump operation (for RHD)



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A


2. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Depress the brake pedal more than 40 times.

  1. Turn the ignition switch to ON.

  1. Wait until the pump motor stops.

  1. Wait for 15 minutes.

  1. Depress the brake pedal and release it.

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (for LHD)
    B
    DTC is output (for RHD)
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

CHECK FOR INTERMITTENT PROBLEMS (Click here)


← C1253/53 Pump Motor Relay Malfunction (Sep 2011 – Dec 2011)C1254/54 Pressure Switch Circuit (Sep 2011 – Dec 2011) →