C1254/54 Pressure Switch Circuit
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
DESCRIPTION
The accumulator pressure sensor is connected to the skid control ECU in the master cylinder solenoid.

| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1254/54 |
There is an accumulator pressure sensor malfunction (the fluid pressure does not change when the pump operates or when the brake is applied). |
|
INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform zero point calibration (Click here).
| 1. READ VALUE USING INTELLIGENT TESTER (ACCUMULATOR SENSOR) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Depress the brake pedal more than 20 times.
Turn the ignition switch to ON and turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Accumulator Sensor
Accumulator pressure sensor reading / min.: 0.00 V, max.: 5.00 V
3.58 to 5 V
If the value is constant regardless of the pump operation, an accumulator pressure sensor malfunction is suspected.
Check the accumulator output value.
Result Result
Proceed to
Output value is within the "Normal Condition" range
A
Output value is out of the "Normal Condition" range
for LHD
B
Output value is constant regardless of pump operation
Output value is out of the "Normal Condition" range
for RHD
C
Output value is constant regardless of pump operation
|
|
||||
|
|
||||
| A | |
| 2. READ VALUE USING INTELLIGENT TESTER (MASTER CYLINDER SENSOR) |
Turn the ignition switch off.
Depress the brake pedal more than 20 times.
Install the brake pedal effort gauge (SST), and bleed air.
- SST
- 09709-29018
Turn the ignition switch to ON and turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Master Cylinder Sensor
Master cylinder pressure sensor reading / min.: 0.00 V, max.: 5.00 V
0.3 to 1.8 V
With pedal effort of 49 N (5 kgf, 11 in.*lbf)
The front brake pressure is 930 to 2130 kPa (9.5 to 21.7 kgf/cm2, 135 to 309 psi).
Check that the master cylinder pressure sensor output value is normal.
- OK:
- Master cylinder pressure sensor value is normal.
Result
Proceed to
OK
A
NG
for LHD
B
for RHD
C
|
|
||||
|
|
||||
| A | |
| 3. RECONFIRM DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Depress the brake pedal more than 20 times.
Turn the ignition switch to ON.
Wait until the pump motor stops.
Depress the brake pedal and release it.
Wait for 25 minutes.
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC is not output
A
DTC is output
for LHD
B
for RHD
C
|
|
||||
|
|
||||
| A | ||
| ||
