2011-2013 Land Cruiser · Service Manual Brake

C1248/48 Open Circuit in Rear Differential Lock

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

DTC No.
DTC Detection Condition
Trouble Area
C1248/48
With the vehicle speed at 50 km/h (30 mph) or more, the rear differential lock position switch changes from off to on and 3 seconds or more elapse.
  1. Rear differential lock position switch (No. 1 transfer indicator switch)
  2. Master cylinder solenoid (Skid control ECU)
  3. Harness or connector

WIRING DIAGRAM

C173282E03

INSPECTION PROCEDURE


1. INSPECT REAR DIFFERENTIAL LOCK POSITION SWITCH (NO. 1 TRANSFER INDICATOR SWITCH)

  1. Measure the resistance according to the value(s) in the table below.C177818E01

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    2 (+B) - 1 (GND)
    Pushed
    Below 1 Ω
    Not pushed
    10 kΩ or higher



NG
REPLACE NO. 1 TRANSFER INDICATOR SWITCH (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (DIFFERENTIAL LOCK SWITCH - SKID CONTROL ECU AND BODY GROUND)

  1. C177521E01
    Disconnect the A24 skid control ECU connector.

  1. Disconnect the f2 differential lock switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Tester Connection
    f2-2 (+B) - A24-26 (EXI3)
    Always
    Below 1 Ω
    f2-2 (+B) - Body ground
    Always
    10 kΩ or higher
    f2-1 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK DTC
  1. Clear the DTC (Click here).

  1. Drive the vehicle at 50 km/h (30 mph) or more.

  1. Check if the same DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    LHD
    B
    RHD
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← C1246/46 Master Cylinder Pressure Sensor Malfunction (Sep 2011 – Dec 2011)C1249/49 Open in Stop Light Switch Circuit (Sep 2011 – Dec 2011) →