2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

U0101 Lost Communication with TCM

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

The Transmission Control Module (TCM) and ECM perform 2-way communications with each other via the Controller Area Network (CAN). The TCM sends signals to the ECM concerning required engine speed, required engine torque, warning indicator speed, opening angles of the throttle valve, temperature of intake air, temperature of engine coolant, engine torque and other data. If the TCM cannot communicate with the ECM, the TCM will conclude that there is a malfunction in the CAN system, illuminate the MIL and store a DTC.
DTC Code
DTC Detection Condition
Trouble Area
U0101
No communication from the TCM continues.
  1. Open or short in TCM and ECM circuit
  2. TCM
  3. ECM

INSPECTION PROCEDURE


1. CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC U0101)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the tester on.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read the DTCs.

    Result 
    Result
    Proceed to
    U0101 is output
    A
    U0101 and other DTCs are output
    B



B
GO TO DTC CHART (Click here)
A


2. REPLACE ECM
  1. Replace the ECM (Click here).


NEXT


3. CHECK WHETHER DTC OUTPUT RECURS
  1. Connect the intelligent tester to the DLC3.

  1. Clear the DTC (Click here).

  1. Start the engine.

  1. Turn the tester on.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read the DTCs.

    Result 
    Result
    Proceed to
    No DTC is output
    A
    Other DTCs are output
    B



B
GO TO DTC CHART (Click here)
A

END


← P2A00 A/F Sensor Circuit Slow Response (Bank 1 Sensor 1) (+ P2A03) (Sep 2011 – Dec 2011)ECM Power Source Circuit (Sep 2011 – Dec 2011) →