C1381 Acceleration Sensor Power Supply Voltage Malfunction
Diagnostic trouble codes · Vehicles built from Jan 2012
DESCRIPTION
The skid control ECU (master cylinder solenoid) receives signals from the yaw rate sensor assembly via the CAN communication system.The yaw rate sensor assembly has a built-in acceleration sensor and detects the vehicle's condition using 2 circuits (GL1, GL2).
If there is trouble in the bus lines between the yaw rate sensor assembly and the CAN communication system, DTCs U0123 (malfunction in CAN communication with the yaw rate sensor) and U0124 (malfunction in CAN communication with the acceleration sensor) are stored.
These DTCs are also stored when calibration has not been completed.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1381 |
At a vehicle speed of more than 3 km/h (2 mph), the acceleration sensor power source malfunction signal is received for 10 seconds or more. |
|
WIRING DIAGRAM
Refer to DTCs C1232, C1243 and C1245 (Click here).INSPECTION PROCEDURE
- NOTICE:
- After replacing the yaw rate sensor assembly, perform calibration (Click here).
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- After replacing the yaw rate sensor assembly, perform calibration (Click here).
| 1. CHECK DTC (CAN COMMUNICATION SYSTEM) |
Check for DTCs (Click here).
Result Result
Proceed to
CAN DTC is not output
A
CAN DTC is output (for LHD)
B
CAN DTC is output (for RHD)
C
|
|
||||
|
|
||||
| A | |
| 2. CHECK HARNESS AND CONNECTOR (IG/+B TERMINAL) |
Turn the ignition switch off.
Disconnect the yaw rate sensor assembly connector.
Measure the voltage according to the value(s) in the table below.

- Standard Voltage:
Tester Connection
Condition
Specified Condition
E50-4 (IG) - Body ground
Ignition switch ON
11 to 14 V
E50-6 (+B) - Body ground
Always
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Yaw Rate Sensor Assembly)
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (GND TERMINAL) |
![]() ![]() |
Turn the ignition switch off.
Disconnect the yaw rate sensor assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E50-1 (GND) - Body ground
Always
Below 1 Ω
Text in Illustration *a
Front view of wire harness connector
(to Yaw Rate Sensor Assembly)
|
|
||||
| OK | |
| 4. RECONFIRM DTC |
Reconnect the yaw rate sensor assembly connector.
Clear the DTCs (Click here).
Turn the ignition switch off.
Start the engine.
Perform a road test.
Check if the same DTC is output (Click here).
| Result |
Proceed to |
| DTC C1381 is not output |
A |
| DTC C1381 is output |
B |
|
|
||||
| A | ||
| ||

