Power Back Door Warning Buzzer Circuit
Circuit diagnosis · Vehicles built from Jan 2012
DESCRIPTION
The power back door unit assembly (power back door ECU) receives the power back door ON/OFF switch signal to sound the power back door warning buzzer.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (PBD BUZZER) |
Select the Active Test, use the intelligent tester to generate a control command, and check that the power back door warning buzzer sounds (Click here).
Back Door Tester Display
Test Part
Control Range
Diagnostic Note
PBD Buzzer
Operate warning buzzer
ON / OFF
-
- OK:
- Power back door warning buzzer sounds normally.
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (POWER BACK DOOR WARNING BUZZER - POWER BACK DOOR UNIT ASSEMBLY AND BODY GROUND) |
Disconnect the K47 power back door warning buzzer connector.
Disconnect the L52 power back door unit assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
K47-1 (BZR+) - L52-26 (BZR+)
Always
Below 1 Ω
K47-2 (BZR-) - Body ground
Always
Below 1 Ω
K47-1 (BZR+) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 3. REPLACE POWER BACK DOOR WARNING BUZZER |
Temporarily replace the power back door warning buzzer with a new or normally functioning one (Click here).
| NEXT | |
| 4. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (PBD BUZZER) |
Select the Active Test, use the intelligent tester to generate a control command, and check that the power back door warning buzzer sounds (Click here).
Back Door Tester Display
Test Part
Control Range
Diagnostic Note
PBD Buzzer
Operate warning buzzer
ON / OFF
-
- OK:
- Power back door warning buzzer sounds normally.
|
|
||||
| OK | ||
| ||
