2011-2013 Land Cruiser · Service Manual Vehicle Exterior

Power Back Door Opener / Closer Switch Circuit

Circuit diagnosis · Vehicles built from Jan 2012

DESCRIPTION

The door control switch only turns on while the switch is being pressed, and turns off when the switch is released.
When the switch is on, a power back door operation request signal is input to the main body ECU (cowl side junction block LH) to operate the back door.

WIRING DIAGRAM

B312261E02

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (BACK DOOR OPEN SW)
  1. Check the Data List for proper functioning of the door control switch (Click here).

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Back Door Open SW
    Door control switch signal / ON or OFF
    ON: Door control switch on
    OFF: Door control switch off
    -

    OK:
    The display is as specified in the normal condition.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT DOOR CONTROL SWITCH
  1. Remove the door control switch (Click here).

  1. Inspect the door control switch (Click here).



NG
REPLACE DOOR CONTROL SWITCH (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (DOOR CONTROL SWITCH - MAIN BODY ECU [COWL SIDE JUNCTION BLOCK LH] AND BODY GROUND)
  1. Disconnect the E105 door control switch connector.

  1. Disconnect the E2 main body ECU (cowl side junction block LH) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E105-6 (CSW) - E2-2 (PBDS)
    Always
    Below 1 Ω
    E105-3 (E) - Body ground
    Always
    Below 1 Ω
    E105-6 (CSW) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)


← Back Door Lock Motor Circuit (from Jan 2012)Power Back Door Warning Buzzer Circuit (from Jan 2012) →