2011-2013 Land Cruiser · Service Manual Vehicle Interior

B2281 "P" Signal Malfunction

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This DTC is stored when there is an abnormal circuit between the main body ECU and the shift lock control ECU.
DTC Code
Detection Condition
Trouble Area
B2281
Communication or the communication line is abnormal between the main body ECU and shift lock control ECU.
  1. Main body ECU
  2. Shift lock control ECU
  3. Harness or connector

WIRING DIAGRAM

C162995E03

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (SHIFT P SIGNAL)
  1. Use the Data List to check if the shift position signal is functioning properly.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Shift P Signal
    Shift P position signal/ON or OFF
    ON: Shift lever in P
    OFF: Shift lever not in P
    -
    Result 
    Result
    Proceed to
    Display on the intelligent tester does not change according to shift lever operation
    A
    Display on the intelligent tester changes according to shift lever operation
    B



B
REPLACE MAIN BODY ECU
A


2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - SHIFT LOCK CONTROL ECU AND BODY GROUND)
C164721E02
  1. Disconnect the E4 main body ECU connector.

  1. Disconnect the E51 shift lock control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E4-2 (P) - E51-11 (P2)
    Always
    Below 1 Ω
    E51-3 (E) - Body ground
    Always
    Below 1 Ω
    E4-2 (P) or E51-11 (P2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT SHIFT LOCK CONTROL ECU

  1. C164810E05
    C165581E01
    Check the signal waveform according to the condition(s) in the table below.
    Reference 
    Terminal No. (Symbol)
    Tool Setting
    Condition
    E51-11 (P2) - E51-3 (E)
    2 V/DIV., 20 msec./DIV.
    Shift lever in P

    OK:
    The waveform is similar to that shown in the illustration.

    Result 
    Result
    Proceed to
    OK
    A
    NG
    for 1GR-FE, 2UZ-FE
    B
    for 1VD-FTV, 3UR-FE
    C



B
REPLACE SHIFT LOCK CONTROL ECU (Click here)

C
REPLACE SHIFT LOCK CONTROL ECU (Click here)
A

REPLACE MAIN BODY ECU


← B2278 Engine Switch Circuit Malfunction (from Jan 2012)B2281 "P" Signal Malfunction (from Jan 2012) →