2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

P060E Internal Control Module Throttle Position Performance

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

The ECM monitors the input signals of the Throttle Position (TP) sensor No. 1 and stop light switch. As the ECM monitors the input signals of the TP sensor No. 1 and the STP signals of the stop light switch, if the input signals and control signals are deviated, a DTC is stored.
DTC Code
DTC Detection Condition
Trouble Area
P060E
When either condition below is met:
  1. An ECM main CPU error.
  2. An ECM sub CPU error.
  3. HO2S transistors malfunction
ECM

INSPECTION PROCEDURE


1. CHECK DTC
  1. Clear DTC (Click here).

  1. Turn the engine switch off.

  1. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) battery terminal.

  1. Start the engine.

  1. Check DTC.

    OK:
    P060E is not output.



NG
REPLACE ECM (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)


← P060D Internal Control Module Accelerator Pedal Position Performance (Sep 2011 – Dec 2011)P0617 Starter Relay Circuit High (Sep 2011 – Dec 2011) →