2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

P060D Internal Control Module Accelerator Pedal Position Performance

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

The ECM monitors the input signals of the Accelerator Pedal Position (APP) sensor No. 1. When the input signals and control signals are deviated, a DTC is stored.
DTC Code
DTC Detection Condition
Trouble Area
P060D
When either condition below is met:
  1. An ECM main CPU error.
  2. An ECM sub CPU error.
ECM

INSPECTION PROCEDURE

HINT:
Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.


1. CHECK DTC
  1. Clear DTC (Click here).

  1. Turn the engine switch off.

  1. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) battery terminal.

  1. Turn the engine switch on (IG).

  1. Check for DTC.

    OK:
    P060D is not output.



NG
REPLACE ECM (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)


← P060B Internal Control Module A/D Processing Performance (Sep 2011 – Dec 2011)P060E Internal Control Module Throttle Position Performance (Sep 2011 – Dec 2011) →