2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

P0657 Actuator Supply Voltage Circuit / Open

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

The ECM monitors the output voltage to the throttle actuator. This self-check ensures that the ECM is functioning properly. The output voltage usually is 0 V when the engine switch is turned off. If the output voltage is higher than 7 V when the engine switch is turned off, the ECM will illuminate the MIL and store a DTC when the engine switch is turned on (IG).
DTC Code
DTC Detection Condition
Trouble Area
P0657
A throttle actuator power supply error.
ECM

INSPECTION PROCEDURE


1. CHECK DTC
  1. Clear DTC (Click here).

  1. Turn the engine switch off.

  1. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) battery terminal.

  1. Turn the engine switch on (IG) for 10 seconds.

  1. Turn the engine switch off.

  1. Turn the engine switch on (IG).

  1. Check for DTC.

    OK:
    P0657 is not output.



NG
REPLACE ECM (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)


← P0617 Starter Relay Circuit High (Sep 2011 – Dec 2011)P0660 Intake Manifold Tuning Valve Control Circuit / Open (Bank 1) (Sep 2011 – Dec 2011) →