2011-2013 Land Cruiser · Service Manual Brake

REMOVAL

Removal / installation · Vehicles built from Sep 2011


1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start the engine.

  1. Turn the A/C switch on.

  1. Operate the cooler compressor while the engine speed is approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.


2. REMOVE LOWER CONSOLE BOX (w/o Console Box Lid)
(Click here)

3. REMOVE COOLING BOX ASSEMBLY (w/ Cool Box)
(Click here)

4. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY (w/o Cool Box)
(Click here)

5. REMOVE PARKING BRAKE LEVER SUB-ASSEMBLY
  1. Release the parking brake lever.

  1. Disconnect the parking brake switch connector.

  1. C170906
    Remove the adjusting nut.

  1. C226757
    Remove the parking brake return spring.

  1. Disconnect the No. 2 parking brake cable and No. 3 parking brake cable from the No. 1 parking brake pull rod.

  1. Remove the No. 1 parking brake pull rod, bush and compression spring from the parking brake lever.

  1. Remove the straight pin from the parking brake lever.

  1. C226756
    Remove the 4 bolts and parking brake lever.


6. REMOVE PARKING BRAKE SWITCH ASSEMBLY
  1. Remove the screw and parking brake switch.

← COMPONENTS (from Sep 2011)INSTALLATION (from Sep 2011) →