2011-2013 Land Cruiser · Service Manual Vehicle Interior

B2074 Driver Side Seat Belt Buckle Switch Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This DTC is stored when there is a malfunction in the front seat inner belt buckle switch circuit for the driver side. The seat belt control ECU receives buckle switch condition information from the center airbag sensor via the CAN communication line and controls the pre-crash safety system.
When DTC B2074 is stored, DTC B1655 is also output.
DTC Code
DTC Detection Condition
Trouble Area
B2074
Malfunction in the front seat inner belt (buckle switch) circuit.
  1. Front seat inner belt LH assembly
  2. Center airbag sensor
  3. Seat belt control ECU
  4. CAN communication system

WIRING DIAGRAM

E149011E03

INSPECTION PROCEDURE

NOTICE:
If DTC B1655 is not cleared, DTC B2074 continues to be output.


1. CHECK DTC (CAN COMMUNICATION SYSTEM)
  1. Use the intelligent tester to check if the CAN communication system is functioning normally (Click here for LHD, Click here for RHD).

    Result 
    Result
    Proceed to
    OK
    (DTC U0151 is not output)
    A
    NG
    (for LHD)
    B
    NG
    (for RHD)
    C

    HINT:
    DTC U0151: Lost Communication with Airbag ECU



B
GO TO CAN COMMUNICATION SYSTEM (DIAGNOSIS SYSTEM) (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (DIAGNOSIS SYSTEM) (Click here)
A


2. CHECK DTC (AIRBAG SYSTEM)
  1. Using the intelligent tester, enter the following menus: Body / SRS Airbag / Trouble Code.

  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B1655 is not output.

    HINT:
    DTC B1655: Driver Side Seat Belt Buckle Switch Circuit Malfunction



NG
GO TO AIRBAG SYSTEM (DTC B1655) (Click here)
OK


3. CHECK DTC (PRE-CRASH SAFETY SYSTEM)
  1. Using the intelligent tester, enter the following menus: Body / Pre-Crash / Trouble Code.

  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    OK
    (DTC B2074 is not output)
    A
    NG
    (for LHD)
    B
    NG
    (for RHD)
    C



B
REPLACE SEAT BELT CONTROL ECU (Click here)

C
REPLACE SEAT BELT CONTROL ECU (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← B2074 Driver Side Seat Belt Buckle Switch Circuit Malfunction (Sep 2011 – Dec 2011)B2075 Passenger Side Seat Belt Buckle Switch Circuit Malfunction (Sep 2011 – Dec 2011) →