2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

C1AE4 Front Right Sensor Malfunction

Diagnostic trouble codes · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The No. 1 ultrasonic sensor (FR sensor) is installed on the front bumper. The ECU detects obstacles based on signals received from the No. 1 ultrasonic sensor (FR sensor). If the No. 1 ultrasonic sensor (FR sensor) has an open circuit or other malfunction, it will not function normally.
DTC Code
DTC Detection Condition
Trouble Area
C1AE4
A malfunction of the No. 1 ultrasonic sensor (FR sensor).
  1. No. 1 ultrasonic sensor (FR sensor)
  2. Parking assist ECU*1
  3. Clearance warning ECU assembly*2
  1. *1: w/ Side Monitor System
  2. *2: w/o Side Monitor System

INSPECTION PROCEDURE

NOTICE:
If the DTC is output after repairs, turn the engine switch on (IG) and move the shift lever to R. Then clear the DTC.


1. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC C1AE4 is not output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)

2. REPLACE NO. 1 ULTRASONIC SENSOR (FR SENSOR)
  1. Replace the No. 1 ultrasonic sensor (FR sensor) with a normally functioning one (Click here).


NEXT


3. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC C1AE4 is not output
    A
    DTC C1AE4 is output (w/ Side Monitor System)
    B
    DTC C1AE4 is output (w/o Side Monitor System)
    C



B
REPLACE PARKING ASSIST ECU (Click here)

C
REPLACE CLEARANCE WARNING ECU ASSEMBLY (Click here)
A

END (NO. 1 ULTRASONIC SENSOR [FR SENSOR] IS DEFECTIVE)


← C1AE4 Front Right Sensor Malfunction (Sep 2011 – Dec 2011)C1AE6 Rear Left Sensor Malfunction (Sep 2011 – Dec 2011) →