2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

C1AE6 Rear Left Sensor Malfunction

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The No. 2 ultrasonic sensor LH is installed on the rear bumper. The ECU detects obstacles based on signals received from the No. 2 ultrasonic sensor LH. If the No. 2 ultrasonic sensor LH has an open circuit or other malfunction, it will not function normally.
DTC Code
DTC Detection Condition
Trouble Area
C1AE6
A malfunction of the No. 2 ultrasonic sensor LH.
  1. No. 2 ultrasonic sensor LH
  2. Parking assist ECU*1
  3. Clearance warning ECU*2

HINT:
*1: w/ Parking Assist Monitor System
*2: w/o Parking Assist Monitor System


INSPECTION PROCEDURE

NOTICE:
If the DTC is output after repairs, turn the engine switch on (IG) and move the shift lever to R. Then clear the DTC.


1. CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC C1AE6 is output
    A
    No DTC is output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A


2. REPLACE NO. 2 ULTRASONIC SENSOR LH
  1. Replace the No. 2 ultrasonic sensor LH with a normally functioning sensor (Click here).


NEXT


3. CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC C1AE6 is output (w/ Parking Assist Monitor System)
    A
    DTC C1AE6 is output (w/o Parking Assist Monitor System)
    B
    No DTC is output
    C



B
REPLACE CLEARANCE WARNING ECU (Click here)

C
END (NO. 2 ULTRASONIC SENSOR LH IS DEFECTIVE)
A

REPLACE PARKING ASSIST ECU (Click here)


← C1AE4 Front Right Sensor Malfunction (from Jan 2012)C1AE6 Rear Left Sensor Malfunction (from Jan 2012) →