2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)
  1. Remove the front seat assembly (Click here).


4. REMOVE FRONT SEAT ASSEMBLY (for Power Seat)
  1. Remove the front seat assembly (Click here).


5. REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Manual Seat)
  1. Disconnect the connectors and detach the clamps.

  1. B189677
    Remove the nut and front seat inner belt assembly.


6. REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Power Seat)
  1. Disconnect the connectors and detach the clamps.

  1. B185874
    Remove the nut and front seat inner belt assembly.

← REMOVAL (Sep 2011 – Dec 2011)INSPECTION (from Sep 2011) →