2011-2013 Land Cruiser · Service Manual Vehicle Interior

B1442/42 Air Inlet Damper Control Servo Motor Circuit

Diagnostic trouble codes · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The REC/FRS damper servo motor sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on the signals to move the air inlet damper to any position, which controls the intake air settings (fresh, fresh/recirculation and recirculation).

HINT:
Confirm that no mechanical problem is present because this trouble code can be output when either a damper link or damper is mechanically locked.

DTC Code
DTC Detection Condition
Trouble Area
B1442/42
The air inlet damper position does not change even if the air conditioning amplifier assembly operates the REC/FRS damper servo motor.
  1. REC/FRS damper servo motor
  2. Air conditioning harness assembly
  3. Air conditioning amplifier assembly

WIRING DIAGRAM

E161749E03
E161749E04

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (REC/FRS DAMPER SERVO MOTOR)
  1. Use the Data List to check if the servo motor is functioning properly.

    Air Conditioner 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Air Inlet Damper Targ Pulse
    REC/FRS damper servo motor target pulse /
    Min.: 9, Max.: 37
    for LHD
    Recirculation: 37 (pulse)
    Fresh: 9 (pulse)
    for RHD
    Recirculation: 9 (pulse)
    Fresh: 37 (pulse)
    -

    OK:
    The display is as specified in the normal condition.



NG
Go to step 2
OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)

2. CHECK REC/FRS DAMPER SERVO MOTOR (OPERATION)
  1. for LHD:

    1. Replace the REC/FRS damper servo motor (Click here).

  1. for RHD

    1. Replace the REC/FRS damper servo motor (Click here).

      HINT:
      Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a normal one.


NEXT


3. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B1442 is not output.

    Result 
    Result
    Proceed to
    OK (for LHD)
    A
    OK (for RHD)
    B
    NG (for LHD)
    C
    NG (for RHD)
    D



B
REPLACE REC/FRS DAMPER SERVO MOTOR (Click here)

C
REPLACE AIR CONDITIONING HARNESS ASSEMBLY (Click here)

D
REPLACE AIR CONDITIONING HARNESS ASSEMBLY (Click here)
A

REPLACE REC/FRS DAMPER SERVO MOTOR (Click here)


← B1442/42 Air Inlet Damper Control Servo Motor Circuit (Sep 2011 – Dec 2011)B1443/43 Air Outlet Damper Control Servo Motor Circuit (Sep 2011 – Dec 2011) →