2011-2013 Land Cruiser · Service Manual Vehicle Interior

B1449/49 Rear Air Outlet Damper Control Servo Motor Circuit

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The rear air outlet damper servo motor sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on the signals to move the rear air outlet damper to the appropriate position, which controls the air outlet modes.

HINT:
Confirm that no mechanical problem is present because this trouble code can be output when either a damper link or damper is mechanically locked.
DTC Code
DTC Detection Condition
Trouble Area
B1449/49
The rear air outlet damper position does not change even if the air conditioning amplifier assembly operates the rear air outlet damper servo motor.
  1. Rear air outlet damper servo motor
  2. No. 2 air conditioning harness assembly
  3. Harness or connector between No. 2 air conditioning harness assembly and air conditioning amplifier assembly
  4. Air conditioning amplifier assembly


WIRING DIAGRAM

E156903E04

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (REAR AIR OUTLET DAMPER SERVO MOTOR)
  1. Use the Data List to check if the servo motor is functioning properly.

    Air Conditioner 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Air Outlet Servo Pulse (R)
    Rear air outlet damper servo motor target pulse /
    Min.: 7, Max.: 83
    Foot: 7 (pulse)
    B/L: 42 (pulse)
    FACE: 83 (pulse)
    -

    OK:
    The display is as specified in the normal condition.



NG
Go to step 2
OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)

2. CHECK HARNESS AND CONNECTOR (NO. 2 AIR CONDITIONING HARNESS - AIR CONDITIONING AMPLIFIER)
E156907E08
  1. Disconnect the K19 No. 2 air conditioning harness assembly connector.

  1. Disconnect the E36 amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K19-2 (RBUG) - E36-12 (RBUG)
    Always
    Below 1 Ω
    K19-3 (RBUS) - E36-13 (RBUS)
    K19-4 (RBBU) - E36-14 (RBBU)
    E36-12 (RBUG) - Body ground
    Always
    10 kΩ or higher
    E36-13 (RBUS) - Body ground
    E36-14 (RBBU) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK REAR AIR OUTLET DAMPER SERVO MOTOR (OPERATION)
  1. Replace the rear air outlet damper servo motor (Click here).

    HINT:
    Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a normal one.


NEXT


4. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B1449 is not output.



NG
REPLACE NO. 2 AIR CONDITIONING HARNESS ASSEMBLY (Click here)
OK

REPLACE REAR AIR OUTLET DAMPER SERVO MOTOR (Click here)


← B1448/48 Passenger Side FACE Servo Motor Circuit (from Jan 2012)B1449/49 Rear Air Outlet Damper Control Servo Motor Circuit (from Jan 2012) →