B1449/49 Rear Air Outlet Damper Control Servo Motor Circuit
Diagnostic trouble codes · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
The rear air outlet damper servo motor sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on the signals to move the rear air outlet damper to the appropriate position, which controls the air outlet modes.- HINT:
- Confirm that no mechanical problem is present because this trouble code can be output when either a damper link or damper is mechanically locked.
DTC Code
DTC Detection Condition
Trouble Area
B1449/49
The rear air outlet damper position does not change even if the air conditioning amplifier assembly operates the rear air outlet damper servo motor.
- Rear air outlet damper servo motor
- No. 2 air conditioning harness assembly
- Harness or connector between No. 2 air conditioning harness assembly and air conditioning amplifier assembly
- Air conditioning amplifier assembly
- Rear air outlet damper servo motor
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (REAR AIR OUTLET DAMPER SERVO MOTOR) |
Use the Data List to check if the servo motor is functioning properly.
Air Conditioner Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Air Outlet Servo Pulse (R)
Rear air outlet damper servo motor target pulse /
Min.: 7, Max.: 83
Foot: 7 (pulse)
B/L: 42 (pulse)
FACE: 83 (pulse)
-
- OK:
- The display is as specified in the normal condition.
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (NO. 2 AIR CONDITIONING HARNESS - AIR CONDITIONING AMPLIFIER) |
![]() ![]() |
Disconnect the K19 No. 2 air conditioning harness assembly connector.
Disconnect the E36 amplifier connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
K19-2 (RBUG) - E36-12 (RBUG)
Always
Below 1 Ω
K19-3 (RBUS) - E36-13 (RBUS)
K19-4 (RBBU) - E36-14 (RBBU)
E36-12 (RBUG) - Body ground
Always
10 kΩ or higher
E36-13 (RBUS) - Body ground
E36-14 (RBBU) - Body ground
|
|
||||
| OK | |
| 3. CHECK REAR AIR OUTLET DAMPER SERVO MOTOR (OPERATION) |
Replace the rear air outlet damper servo motor (Click here).
- HINT:
- Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a normal one.
| NEXT | |
| 4. CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
- OK:
- DTC B1449 is not output.
|
|
||||
| OK | ||
| ||

