2011-2013 Land Cruiser · Service Manual Power Source / Network

B1273 Sliding Roof ECU Communication Stop

Diagnostic trouble codes · Vehicles built from Sep 2011

DESCRIPTION

This DTC is stored when LIN communication between the sliding roof ECU and main body ECU (cowl side junction block LH) stops for 10 seconds or more.
DTC Code
DTC Detection Condition
Trouble Area
B1273
No communication between the sliding roof ECU and main body ECU (cowl side junction block LH) for 10 seconds or more.
  1. Sliding roof ECU
  2. Main body ECU (cowl side junction block LH)
  3. Harness or connector

WIRING DIAGRAM

B173719E14

INSPECTION PROCEDURE

NOTICE:
When using the intelligent tester with the ignition switch off to troubleshoot:
Connect the intelligent tester to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the intelligent tester and vehicle begins.

HINT:
DTC B2325 is stored when the communication between the sliding roof ECU and main body ECU (cowl side junction block LH) stops.


1. CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


2. CHECK FOR DTC
  1. Recheck for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC B1273 is output
    A
    DTC B1273 is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A


3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - SLIDING ROOF ECU)
E156401E01
  1. Disconnect the E3 and R5 ECU connectors.

  1. Measure the resistance and voltage according to the value(s) in the tables below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E3-10 (LIN2) - R5-4 (MPX1)
    Always
    Below 1 Ω
    E3-10 (LIN2) or R5-4 (MPX1) - Body ground
    Always
    10 kΩ or higher

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    R5-4 (MPX1) - Body ground
    Always
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK SLIDING ROOF ECU (BATTERY VOLTAGE AND BODY GROUND)

  1. B163105E06
    Disconnect the R5 ECU connector.

  1. Measure the resistance and voltage according to the value(s) in the tables below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R5-2 (E) - Body ground
    Always
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    R5-1 (B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5. REPLACE SLIDING ROOF ECU
  1. Temporarily replace the sliding roof ECU with a new or normally functioning one (Click here).

  1. Clear the DTC (Click here).


NEXT


6. CHECK FOR DTC
  1. Recheck for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC B1273 is not output
    A
    DTC B1273 is output
    B



B
REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)
A

END (SLIDING ROOF ECU IS DEFECTIVE)


← B1249 Double Locking ECU Communication Stop (from Sep 2011)B2287 LIN Communication Master Malfunction (from Sep 2011) →