2011-2013 Land Cruiser · Service Manual Power Source / Network

B1249 Double Locking ECU Communication Stop

Diagnostic trouble codes · Vehicles built from Sep 2011

DESCRIPTION

DTC B1249 is stored when communication between the double lock door control relay and main body ECU (cowl side junction block LH) stops for more than 10 seconds.
DTC Code
DTC Detection Condition
Trouble Area
B1249
No communication from the double door lock relay for more than 10 seconds.
  1. Double lock door control relay
  2. Main body ECU (cowl side junction block LH)
  3. Harness or connector

WIRING DIAGRAM

E123927E05

INSPECTION PROCEDURE

NOTICE:
When using the intelligent tester with the ignition switch off to troubleshoot:
Connect the intelligent tester to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the intelligent tester and vehicle begins.

HINT:
DTC B2325 is output when the communication between all of the following components and main body ECU (cowl side junction block LH) stops.


1. CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


2. CHECK FOR DTC
  1. Recheck for DTC (Click here).

    Result: 
    Result
    Proceed to
    DTC B1249 is output
    A
    DTC B1249 is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A


3. CHECK HARNESS AND CONNECTOR (RELAY - MAIN BODY ECU, BATTERY AND BODY GROUND)
B144121E01
  1. Disconnect the E3 ECU connector.

  1. Disconnect the E86 relay connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E86-9 (MPX1) - E3-10 (LIN2)
    Always
    Below 1 Ω
    E86-9 (MPX1) - Body ground
    Always
    10 kΩ or higher
    E3-10 (LIN2) - Body ground
    Always
    10 kΩ or higher
    E86-14 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E86-1 (+B) - Body ground
    Always
    11 to 14 V
    E86-7 (CPUB) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. REPLACE DOUBLE LOCK DOOR CONTROL RELAY
  1. Temporarily replace the double lock door control relay with a new or normally functioning one (Click here)*1, (Click here)*2.

    HINT:
    1. *1: for LHD
    2. *2: for RHD

  1. Clear the DTC (Click here).


NEXT


5. CHECK FOR DTC
  1. Recheck for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC B1249 is not output
    A
    DTC B1249 is output
    B



B
REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)
A

END (DOUBLE LOCK DOOR CONTROL RELAY IS DEFECTIVE)


← B1206 P/W Master Switch Communication Stop (from Jan 2012)B1273 Sliding Roof ECU Communication Stop (from Sep 2011) →