B1206 P/W Master Switch Communication Stop
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
This DTC is stored when LIN communication between the master switch and main body ECU (cowl side junction block LH) stops for 10 seconds or more.| DTC Code |
DTC Detection Condition |
Trouble Area |
| B1206 |
No communication between master switch and main body ECU (cowl side junction block LH) for 10 seconds or more. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When using the intelligent tester with the ignition switch off to troubleshoot:
- Connect the intelligent tester to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the intelligent tester and vehicle begins.
- HINT:
- DTC B2325 is stored when the communication between the master switch and main body ECU (cowl side junction block LH) stops.
| 1. CLEAR DTC |
Clear the DTC (Click here).
| NEXT | |
| 2. CHECK FOR DTC |
Recheck for DTCs (Click here).
Result Result
Proceed to
DTC B1206 is output
A
DTC B1206 is not output
B
|
|
||||
| A | |
| 3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - MASTER SWITCH) |
![]() ![]() |
Disconnect the E3 ECU connector.
Disconnect the I11*1 or I22*2 switch connector.
- HINT:
- *1: for LHD
- *2: for RHD
- *1: for LHD
Measure the resistance and voltage according to the value(s) in the tables below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E3-10 (LIN2) - I11-17 (LIN1)*1 or I22-17 (LIN)*2
Always
Below 1 Ω
E3-10 (LIN2) - Body ground
Always
10 kΩ or higher
- Standard Voltage:
Tester Connection
Condition
Specified Condition
E3-10 (LIN2) - Body ground
Always
Below 1 V
|
|
||||
| OK | |
| 4. CHECK MASTER SWITCH ASSEMBLY (BATTERY VOLTAGE AND BODY GROUND) |
Disconnect the I11*1 or I22*2 switch connector.

- HINT:
- *1: for LHD
- *2: for RHD
- *1: for LHD
Measure the resistance and voltage according to the value(s) in the tables below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
I11-12 (GND)*1 or I22-12 (GND)*2 - Body ground
Always
Below 1 Ω
- Standard Voltage:
Tester Connection
Condition
Specified Condition
I11-11 (B)*1 or I22-11 (B)*2 - Body ground
Always
11 to 14 V
|
|
||||
| OK | |
| 5. REPLACE MASTER SWITCH ASSEMBLY |
Temporarily replace the master switch assembly with a new or normally functioning one (Click here).
Clear the DTC (Click here).
| NEXT | |
| 6. CHECK FOR DTC |
Recheck for DTCs (Click here).
Result Result
Proceed to
DTC B1206 is not output
A
DTC B1206 is output
B
|
|
||||
| A | ||
| ||

