B1488/88 Rear Air Mix Damper Control Servo Motor Circuit on Front Passenger Side
Diagnostic trouble codes · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
The rear air mix damper servo motor RH*1 or LH*2 sends pulse signals to indicate the damper position to the air conditioning amplifier assembly. The air conditioning amplifier assembly activates the motor (normal or reverse) based on these signals to move the rear air mix damper to the appropriate position. This adjusts the amount of air passing through the heater core after passing the evaporator and controls the temperature of the blown air.- HINT:
- Confirm that no mechanical problem is present because this trouble code can be output when either a damper link or damper is mechanically locked.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| B1488/88 |
The rear air mix damper position does not change even if the air conditioning amplifier assembly operates the air mix damper servo motor. |
|
- HINT:
- *1: for LHD
- *2: for RHD
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (REAR AIR MIX DAMPER SERVO MOTOR) |
Use the Data List to check if the servo motor is functioning properly.
Air Conditioner Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
A/M Servo Targ Pulse (Rear P)
Rear air mix damper servo motor (for front passenger side) target pulse /
Min.: 8, Max.: 53 (for LHD)
Min.: 9, Max.: 54 (for RHD)
for LHD - MAX COOL: 53 (pulse)
- MAX HOT: 8 (pulse)
- MAX COOL: 9 (pulse)
- MAX HOT: 54 (pulse)
-
- OK:
- The display is as specified in the normal condition.
- MAX COOL: 53 (pulse)
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (NO. 2 AIR CONDITIONING HARNESS - AIR CONDITIONING AMPLIFIER) |
![]() ![]() |
Disconnect the K19 No. 2 air conditioning harness connector.
Disconnect the E36 amplifier connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
K19-2 (RBUG) - E36-12 (RBUG)
Always
Below 1 Ω
K19-3 (RBUS) - E36-13 (RBUS)
K19-4 (RBBU) - E36-14 (RBBU)
E36-12 (RBUG) - Body ground
Always
10 kΩ or higher
E36-13 (RBUS) - Body ground
E36-14 (RBBU) - Body ground
|
|
||||
| OK | |
| 3. CHECK REAR AIR MIX DAMPER SERVO MOTOR (OPERATION) |
Replace the rear air mix damper servo motor (Click here).
- HINT:
- Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a normal one.
| NEXT | |
| 4. CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
- OK:
- DTC B1489 is not output.
|
|
||||
| OK | ||
| ||

