2011-2013 Land Cruiser · Service Manual Power Source / Network

U0123 Lost Communication with Yaw Rate Sensor Module

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Also covers:

DESCRIPTION

DTC Code
DTC Detection Condition
Trouble Area
U0123
There is no communication from the yaw rate sensor.
  1. Power source circuit of yaw rate sensor
  2. Yaw rate sensor
  3. Yaw rate sensor branch wire or connector
U0124
There is no communication from the yaw rate sensor (lateral acceleration sensor).
  1. Power source circuit of yaw rate sensor
  2. Yaw rate sensor
  3. Yaw rate sensor branch wire or connector

WIRING DIAGRAM

C176042E01

INSPECTION PROCEDURE


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

    CAUTION:
    For vehicles with an SRS system:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


2. CHECK FOR OPEN IN CAN BUS WIRE (YAW RATE SENSOR BRANCH WIRE)

  1. C150960E05
    Disconnect the E50 yaw rate sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    E50-3 (CANH) - E50-2 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE YAW RATE SENSOR BRANCH WIRE OR CONNECTOR (CANH, CANL)
OK


3. CHECK HARNESS AND CONNECTOR (YAW RATE SENSOR - BATTERY AND BODY GROUND)
  1. Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. C150960E07
    Disconnect the E50 yaw rate sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E50-1 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E50-4 (IG) - Body ground
    Ignition switch ON
    11 to 14 V
    E50-6 (+B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE YAW RATE SENSOR ASSEMBLY (Click here)


← U0122 Lost Communication with Vehicle Dynamics Control Module (+ U0129) (Sep 2011 – Dec 2011)U0125 Lost Communication with Yaw Rate Sensor Module (+ U0124) (from Jan 2012) →