U0125 Lost Communication with Yaw Rate Sensor Module
Diagnostic trouble codes · Vehicles built from Jan 2012
Also covers:
- U0124 Lost Communication with Lateral Acceleration Sensor Module
DESCRIPTION
| DTC Code |
DTC Detection Condition |
Trouble Area |
| U0125 |
There is no communication from the yaw rate sensor assembly. |
|
| U0124 |
There is no communication from the yaw rate sensor assembly (lateral acceleration sensor). |
|
- For vehicles with a vehicle stability control system.
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- HINT:
- Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.
| 1. PRECAUTION |
- NOTICE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
| NEXT | |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and the CAN branch wire.
- CAUTION:
- For vehicles with an SRS system:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| NEXT | |
| 3. CHECK FOR OPEN IN CAN BUS WIRE (YAW RATE SENSOR ASSEMBLY CAN BRANCH WIRE) |
Disconnect the E50 yaw rate sensor assembly connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
E50-3 (CANH) - E50-2 (CANL)
Ignition switch off
54 to 69 Ω
Text in Illustration *a
Front view of wire harness connector
(to Yaw Rate Sensor Assembly)
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (YAW RATE SENSOR ASSEMBLY - BATTERY AND BODY GROUND) |
Connect the cable to the negative (-) battery terminal.

- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
Measure the voltage according to the value(s) in table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
E50-4 (IG) - Body ground
Ignition switch ON
11 to 14 V
E50-6 (+B) - Body ground
Always
11 to 14 V
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E50-1 (GND) - Body ground
Always
Below 1 Ω
| *a |
Front view of wire harness connector (to Yaw Rate Sensor Assembly) |
|
|
||||
| OK | ||
| ||
