2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

P0575 Cruise Control Input Circuit

Diagnostic trouble codes · Vehicles built from Jan 2012

Also covers:

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This DTC indicates the internal abnormalities of the ECM.
DTC Code
DTC Detection Condition
Trouble Area
P0575
When either of the following conditions is met:
  1. STP signals input to the ECM supervisory CPU and control ECU are different for 0.15 seconds or more.
  2. 0.4 seconds have passed after cruise cancel input signal (STP input) is input to the ECM.
ECM (for 1GR-FE, 1UR-FE, 3UR-FE)
P0607
When the cruise control main switch is turned off, the ECM recognizes that the cruise control system is operating.
ECM (for 1VD-FTV, w/o DPF)

HINT:
The ECM receives signals from each sensor to control all functions of the cruise control system. When this trouble code is stored, fail-safe remains on until the ignition switch is turned off.


INSPECTION PROCEDURE


1. CHECK DTC (CRUISE CONTROL SYSTEM)
  1. Using the intelligent tester, enter the following menus: Powertrain / Cruise Control / Trouble Code.

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs (Click here).

    Result 
    Result
    Proceed to
    OK
    (DTC is not output)
    A
    NG
    (DTC P0575 is output for 1GR-FE)
    B
    NG
    (DTC P0575 is output for 1UR-FE)
    C
    NG
    (DTC P0575 is output for 3UR-FE)
    D
    NG
    (DTC P0607 is output for 1VD-FTV, w/o DPF)
    E



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)

D
REPLACE ECM (Click here)

E
REPLACE ECM (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← P0575 Cruise Control Input Circuit (+ P0607) (Sep 2011 – Dec 2011)Clutch Switch Circuit (Sep 2011 – Dec 2011) →