2011-2013 Land Cruiser · Service Manual Vehicle Exterior

Headlight Signal Circuit

Circuit diagnosis · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The main body ECU receives a headlight low switch information signal from the light control switch, and illuminates the headlight low beam.

WIRING DIAGRAM

E246965E03
E246966E02

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (HEADLIGHT)
  1. Using the intelligent tester, perform the Active Test (Click here).

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Headlight Relay
    Headlight
    ON or OFF
    -

    OK:
    Headlight low beam turns on/turns off.



NG
Go to step 2
OK

REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)

2. INSPECT HEADLIGHT RELAY (HEAD LO)

  1. A111813E19
    Remove the headlight relay from the engine room relay block, junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω



NG
REPLACE HEADLIGHT RELAY (HEAD LO)
OK


3. CHECK HARNESS AND CONNECTOR (BATTERY - HEADLIGHT RELAY [HEAD LO])

  1. E160870E02
    Remove the headlight relay from the engine room relay block, junction block.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    Headlight relay terminal 1 - Body ground
    Always
    11 to 14 V
    Headlight relay terminal 5 - Body ground

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Headlight Relay [HEAD LO])



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (HEADLIGHT RELAY [HEAD LO] - MAIN BODY ECU [COWL SIDE JUNCTION BLOCK LH])
  1. Remove the headlight relay from the engine room relay block, junction block.

  1. Disconnect the 2B main body ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Headlight relay terminal 2 - 2B-18
    Always
    Below 1 Ω
    Headlight relay terminal 2 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Headlight Signal Circuit (Sep 2011 – Dec 2011)Door Courtesy Switch Circuit (Sep 2011 – Dec 2011) →