B279A Theft Deterrent System Communication Line High Fixation
Diagnostic trouble codes · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
When the communication line (IMI - EFIO) between the ECM and transponder key ECU assembly is stuck on HI output, the ECM stores this DTC.| DTC Code |
DTC Detection Condition |
Trouble Area |
DTC Output Confirmation Operation |
| B279A |
The communication line (IMI - EFIO) between the ECM and transponder key ECU assembly is stuck on HI output (1 trip detection logic*). |
|
Turn the ignition switch to ON and wait 6 seconds. |
- *: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected |
Fail-safe Operation when Malfunction Detected |
| Engine cannot be started (initial ignition occurs and engine cranks, then ignition stops) |
Engine start is prohibited |
| DTC Code |
Data List and Active Test |
| B279A |
- |
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the transponder key ECU assembly, refer to the Service Bulletin.
- When replacing the ECM, refer to Initialization (Click here).
- After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.
- When replacing the transponder key ECU assembly, refer to the Service Bulletin.
| 1. CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 2. CHECK FOR DTC |
Check for DTCs (Click here).
- HINT:
- Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
- OK:
- DTC B279A is not output.
|
|
||||
| OK | ||
| ||
| 3. CHECK CONNECTION OF CONNECTOR |
Check that the connectors are properly connected to the ECM and transponder key amplifier assembly.
- OK:
- Connectors are properly connected.
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU ASSEMBLY - ECM) |
Disconnect the E96 transponder key ECU assembly connector.
Disconnect the A38*1 or A52*2 ECM connector.
- *1: for LHD
- *2: for RHD
- *1: for LHD
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
for LHD Tester Connection
Condition
Specified Condition
E96-13 (EFIO) - A38-11 (IMI)
Always
Below 1 Ω
E96-13 (EFIO) - Body ground
Always
10 kΩ or higher
for RHD Tester Connection
Condition
Specified Condition
E96-13 (EFIO) - A52-11 (IMI)
Always
Below 1 Ω
E96-13 (EFIO) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 5. REPLACE TRANSPONDER KEY ECU ASSEMBLY |
Replace the transponder key ECU assembly.
| NEXT | |
| 6. REGISTER KEY |
Register the key (refer to the Service Bulletin).
| NEXT | |
| 7. REGISTER ECU COMMUNICATION ID |
Register the ECU communication ID (refer to the Service Bulletin).
| NEXT | |
| 8. CHECK WHETHER ENGINE STARTS |
Check that the engine starts with the key.
- OK:
- Engine starts normally.
Result Result
Proceed to
OK
A
NG (for 1GR-FE)
B
NG (for 1VD-FTV)
C
|
|
||||
|
|
||||
| A | ||
| ||
