2011-2013 Land Cruiser · Service Manual Vehicle Interior

Entire Combination Meter does not Operate

Circuit diagnosis · Vehicles built from Sep 2011

DESCRIPTION

This circuit is the power source circuit for the combination meter. This circuit provides 2 power source types: one is a constant power source mainly used as a backup power source, and the other is a power source mainly used for signal transmission. The constant power source is mainly used as a backup power source for the meter CPU. However, it is also used for communication. If a voltage of 12 V is not applied to terminal IG+ when the ignition switch isON, indicators will not operate.

WIRING DIAGRAM

E156808E02

INSPECTION PROCEDURE


1. INSPECT FUSE (MET, ECU-B1)
  1. Remove the MET and ECU-B1 fuses from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    MET fuse
    Always
    Below 1 Ω
    ECU-B1 fuse



NG
REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - BATTERY AND BODY GROUND)
E157221E01
  1. Disconnect the E7 meter connector.

  1. Measure the resistance and voltage according to the value(s) in the tables below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E7-15 (ET) - Body ground
    Always
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E7-17 (B) - Body ground
    Always
    11 to 14 V
    E7-18 (IG+) - Body ground
    Ignition switch ON

Result 
Result
Proceed to
NG
A
OK (w/ Multi-information Display)
B
OK (w/o Multi-information Display)
C


B
REPLACE COMBINATION METER ASSEMBLY (Click here)

C
REPLACE COMBINATION METER ASSEMBLY (Click here)
A

REPAIR OR REPLACE HARNESS OR CONNECTOR


← U0129 Lost Communication with Brake System Control Module (from Jan 2012)Speedometer Malfunction (Sep 2011 – Dec 2011) →