2011-2013 Land Cruiser · Service Manual Vehicle Exterior

Hazard Warning Switch Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The turn signal flasher receives a hazard warning signal switch information signal, and illuminates the turn signal lights.

WIRING DIAGRAM

E156581E01

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Operate the intelligent tester according to the steps on the display and select "Active Test".

Main Body 
Tester Display
Test Part
Control Range
Diagnostic Note
Hazard
Hazard warning signal
ON or OFF
-

OK:
All hazard warning signal lights flash.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT HAZARD WARNING SIGNAL SWITCH

  1. E143366E04
    Remove the hazard warning signal switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (E) - 4 (F)
    Hazard warning switch on
    Below 1 Ω
    Hazard warning switch off
    10 kΩ or higher



NG
REPLACE HAZARD WARNING SIGNAL SWITCH (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (HAZARD WARNING SIGNAL SWITCH - TURN SIGNAL FLASHER AND BODY GROUND)

  1. E156582E01
    Disconnect the F11 switch connector.

  1. Disconnect the E19 relay connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F11-4 (F) - E19-8 (HAZ)
    Always
    Below 1 Ω
    F11-1 (E) - Body ground
    F11-4 (F) - Body ground
    Always
    10 kΩ or higher

    Result 
    Result
    Proceed to
    OK (for LHD)
    A
    OK (for RHD)
    B
    NG
    C



B
REPLACE TURN SIGNAL FLASHER ASSEMBLY (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE TURN SIGNAL FLASHER ASSEMBLY (Click here)


← Turn Signal Light Circuit (from Jan 2012)Hazard Warning Switch Circuit (from Jan 2012) →