2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Disconnect the cable from the negative (-) main battery and sub-battery terminals.


2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY
  1. Remove the automatic transmission assembly (Click here).


3. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY
  1. Remove the manual transmission unit assembly (Click here).


4. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)

C173317E01
  1. Put matchmarks on the clutch cover and flywheel.

  1. Loosen each set bolt one turn at a time until spring tension is released.

  1. Remove the 8 set bolts, and pull off the clutch cover.

    NOTICE:
    Do not drop the clutch disc.


5. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

NOTICE:
Keep the lining part of the clutch disc, pressure plate and surface of the flywheel away from oil and foreign matter.


6. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)

  1. A185177
    Using a wrench, hold the crankshaft.

    NOTICE:
    Do not turn the crankshaft counterclockwise.
    If it is turned counterclockwise, check that the crankshaft pulley set bolt is not loose. If loose, tighten the bolt (Click here).

    Torque:
    108 N*m{ 1101 kgf*cm , 80 ft.*lbf } or more

  1. A177363
    Remove the 8 bolts.

  1. A177364E01
    Remove the rear drive plate spacer labeled A, drive plate and ring gear labeled B and rear crankshaft balancer weight labeled C.


7. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

  1. A185177
    Using a wrench, hold the crankshaft.

    NOTICE:
    Do not turn the crankshaft counterclockwise.
    If it is turned counterclockwise, check that the crankshaft pulley set bolt is not loose. If loose, tighten the bolt (Click here).

    Torque:
    108 N*m{ 1101 kgf*cm , 80 ft.*lbf } or more

  1. A177365
    Remove the 8 bolts and flywheel.


8. REMOVE REAR CRANKSHAFT OIL SEAL

  1. A177361E01
    Using a knife, cut off the lip of the oil seal.

  1. Using a screwdriver, pry out the oil seal.

    NOTICE:
    Be careful not to damage the crankshaft.

    HINT:
    Tape the screwdriver tip before use.

← COMPONENTS (from Jan 2012)REMOVAL (from Jan 2012) →